Making the end wedge.

So as of this morning, the curly maple was the choice. I needed to setup the bandsaw and resaw some peices for the peghead, wedge and heel cap.

https://www.dropbox.com/s/yoh032gp3979hzo/20210316_093101.jpg?dl=0

https://www.dropbox.com/s/si9ipvxkvf2kje0/20210316_093227.jpg?dl=0

https://www.dropbox.com/s/34zmmhz7rgipzqe/20210316_093923.jpg?dl=0

This was the cut peices:

https://www.dropbox.com/s/9mvdc5e27nob3ja/20210316_094905.jpg?dl=0

ahhh but wait... maybe the customer would like koa from this cutoff:

https://www.dropbox.com/s/onug9soo9qssj6c/20210316_095851.jpg?dl=0

she likes the koa! So I cut the peice down and resaw some for a peghead:

https://www.dropbox.com/s/t5zvucfvfpa3znn/20210316_105445.jpg?dl=0

And then make a wedge and cut a peice for the heel cap:

https://www.dropbox.com/s/0mxa4fy6hl49p62/20210316_134021.jpg?dl=0

I then had to joint the edges and glue the two halves together to make a peghead veneer.

https://www.dropbox.com/s/6ypzit0ralirm6g/20210316_160739.jpg?dl=0

https://www.dropbox.com/s/wkg31i5wp381qxd/20210316_163214.jpg?dl=0

After I started excavating the cavity and fitting the wedge. I will finish with the cavity tomorrow and glue in the wedge and then sand it flush.

https://www.dropbox.com/s/a5368si502h25v2/20210316_161951.jpg?dl=0